How to Set up Dual Hard Drives
- 1). Shut down the computer and unplug it.
- 2). Remove the screws at the back of the case and remove the side panel.
- 3). Set the jumper switch on one of your hard drives to the "Master" setting. Set the other to the "Slave" position.
- 4). Screw both hard drives into the bay at the front of the case. Connect a four-pin molex cable to the power ports of each and an IDE cable to the data port of each.
- 5). Close up your computer and start it. The PC will automatically recognize the installed drives.
Source...