How to Change the Oil on a '95 Harley Davidson Dyna Low Rider
- 1). Run the Low Rider's motor for a few minutes to warm the oil up. Shut off the bike.
- 2). Find your Low Rider's drain plug (on the oil pan). Using the screwdriver, loosen then remove the drain plug, and drain the oil into the drain pan.
- 3). Remove the Low Rider's dipstick.
- 4). Let the oil drain completely.
- 5). Clean the drain plug threads with a clean cloth or paper towel, apply sealant, and replace the oil plug and dipstick.
- 6). Move the drain pan to beneath the oil filter. Using the oil filter wrench, remove the oil filter.
- 7). Discard the filter in the pan with the old oil. It is full of oil.
- 8). With a clean rag or paper towel, clean the area where the gasket meets the motor.
- 9). With a clean finger, rub a bit of new oil on the gasket of the new oil filter before installing it.
- 10
Install the new filter, turning until snug, then turn it by hand another 1/2 turn. Take care to not over-tighten, as this will damage the filter gasket or the filter, possibly causing the Low Rider to fail. - 11
Open the oil reservoir, using the funnel; fill the tank with the fresh oil and close the reservoir. - 12
Run the motor for a few moments to coat the engine with the new oil. Check for leaks. (If you find any, check the filter and drain plug for a tight fit.) - 13
If there are no leaks, after the motor has run for a few minutes, turn off the motor and check the oil level. Top it off if necessary.
Source...