How to Reset the Bushnell Trail Scout Pro
- 1). Open the front cover by turning the center knob 90 degrees until horizontal. Toggle all switches to the center position. Remove the batteries. Leave the batteries out for one minute. Replace the batteries.
- 2). Move the first switch up to the "On" position. Bushnell should show for two seconds on the LED display. Move the switch to the center (Setup) position.
- 3). When the LED shows "Set Date," then press "Enter." Use the "Up" and "Down" buttons to enter the correct date in the month/day/year format. Press "Enter" after entering each section until finished.
- 4). Press "Down" until the LED shows "Set Time," then press "Enter." Use the "Up" and "Down" buttons to set the hour and minute. Press "Enter" after entering each section until finished.
- 5). Press "Down" until the LED shows "My Name," then press "Enter." Use the "Up" and "Down" buttons to select the characters to create a name for the device. Press "Enter" after entering each character until finished.
- 6). Press "Down" until the LED shows "Password Set," then press "Enter." The LED will show "Password Yes." Press "Enter" to set a password or press the "Up" button, then press "Enter," and now password will be set.
If setting a password, use the "Up" and "Down" buttons to set a four-digit password. Press "Enter" after entering each section until finished. - 7). Press "Down" until the LED shows "Set Day Time," then press "Enter." Use the "Up" and "Down" buttons to set the hour for sunrise and the hour for sunset using a 24-hour clock (1pm = 13). Press "Enter" after entering each section until finished.
- 8). Use the other toggle switches to set the operating modes. When finished with setup, move the first toggle switch to the "On" position. Close the front cover and secure by turning the knob 90 degrees until vertical.
Source...