Simplicity Ellis Instructions
- 1). Place the two mattress support bars on the floor with the 10 larger holes facing inward and the four smaller holes on the outside. Insert threaded crossbars into the first, fourth, seventh and tenth holes on one bar and insert the short bolts into the holes on the opposite side. Tighten them down with the Allen wrench and insert the non-threaded crossbars into the remaining holes.
- 2). Place the other mattress support bar onto the ends of the crossbars. Insert the short bolts into the holes on the outside of the bar as you did in Step 1 and secure them into place with the Allen wrench.
- 3). Attach the angled brackets onto each of the four corners of the mattress support you have just assembled. Make sure that the brackets are facing upward and insert a long cone bolt into the holes and secure them in place with the Allen wrench.
- 4). Place a front leg (shorter) and back leg (longer) onto either side of one of the end panel pieces of the crib and insert Allen bolts into the holes on the legs. Secure them with the Allen wrench. Repeat this process for the other end panel piece.
- 5). Attach the back side of the crib assembly to the two end pieces you have just put together using the Allen bolts and the Allen wrench. Attach the top rail to the back side between the two legs using the same bolts and wrench. Attach the mattress support assembly to the bottoms of the legs by inserting a bolt through the brackets and tightening it with the wrench.
- 6). Place the front side onto the crib assembly and insert the remaining Allen bolts into the holes and tighten them down. Once it is in place, place the top rail to the front side using the same method for the back side in Step 5.
- 7). Inspect all places where you attached bolts to make sure they are secure and the crib does not wobble. Tighten any spot that seems a bit loose.
Source...