How to Reset an Outside Sensor Light
- 1). Review the sensor light owner's guide to determine the method recommended for resetting the motion sensor. Most sensor lights require homeowners to turn off the circuit breaker the light is attached to. Make sure no vital appliances are attached to this circuit breaker, such as refrigerators or freezers. Turn off the circuit breaker and wait the suggested amount of time found in the owner's manual, typically 30 seconds to five minutes.
- 2). Turn the circuit breaker back on. If the sensor light is powered by a light switch, make sure the switch is flipped down to the "off" position. Wait up to five minutes before flipping the switch to the "on" position. The sensor light should reset. Test by walking in front of the sensor, if it goes off the sensor has been reset if not, move on to the next step.
- 3). Manually reset the sensor light by flipping its light switch on and off rapidly until the light beam stays continuously on. This notifies you the light is ready to be manually reset, so turn the light switch to the "off" position. Wait one minute then turn the light switch back to the "on" position. The sensor light should now be reset. Test by walking in front of the sensor.
- 4). Locate the reset button found on the motion sensor box, if applicable. Some outdoor sensor lights feature a physical reset button on the side or bottom of the sensor box. Press and hold this button for five-seconds, or however long the owner's manual says it'll take to reset the light. Release the button and the light should be reset.
Source...