Dodge Ram (2002 to 2005)

• 1). Sit in the driver's seat and buckle the seat belt. Make sure all the doors are closed. Put your key in the ignition and turn it to "On." This mode turns on your electronics without cranking the engine.
  
  
• 2). Hold "Unlock" on your working keyless-entry remote. After four seconds, press "Panic" while holding "Unlock." You'll hear a warning chime; release both buttons.
  
  
• 3). Press and release "Unlock" and "Lock" simultaneously on the keyless-entry remote you are programming.
  
  
• 4). Listen for the warning chime. Press "Lock" on the remote you are programming within four seconds of hearing the chime. You'll hear another chime. This indicates the remote is programmed.
  
  

Dodge Dakota and Durango (2001 to 2004)

• 1). Take a seat in your vehicle and close the door. Press "Lock" on a currently-programmed remote five times, allowing two seconds to pass between each press.
  
  
• 2). Place your key in the ignition. Turn it to "Run." Keep it in run until the chiming stops. Once the chiming stops, press and hold "Lock" for four seconds on the programmed remote. After four seconds, press and hold "Panic" along with "Lock" for one second, and then release both buttons. Listen for a single chime.
  
  
• 3). Press and release "Unlock" and "Lock" on the remote you want to program, and then press and release "Unlock." Listen for a single chime. This indicates the remote is programmed.
  
  

Dodge Neon (2000 to 2006)

• 1). Place the key in the ignition. Turn it to "Run." Press and hold "Unlock" for four seconds on the programmed remote.
  
  
• 2). Press and hold "Panic" for one second, while holding "Unlock," and then release both buttons. Listen for the chime.
  
  
• 3). Press any button on the remote you want to program. A single chime is heard, indicating the remote is programmed. Press any button on the previously-programmed remote (it must be resynchronized). Turn the engine off and test each remote.